3DR Radio Telemetry Kit - 915Mhz New Version.2

1,150.00 ฿

ค่าจัดส่ง รวมค่าจัดส่งแล้ว

จำนวน :

รายละเอียดสินค้า

3DR Radio telemetry system

Kick your mission planning into real time with 3DR Radios, featuring interchangeable air and ground modules, Android tablet compatibility, and protective cases. 3DR Radios allow your ground station computer to communicate with your vehicle wirelessly, providing unparalleled ease of use for viewing in-flight data, changing missions on the fly, and tuning.

The 3DR Radio set includes:

Two radio modules with antennas
Micro-USB cable
Android OTG adapter cable
6-wire Pixhawk connector cable
6-to-5-position APM and PX4 connector cable

Documentation:

Specifications:

Interchangeable air and ground modules
915 MHz
Micro-USB port
6-position DF13 connector
100 mW maximum output power (adjustable)
-117 dBm receive sensitivity
Based on HopeRF’s HM-TRP module
RP-SMA connector
2-way full-duplex communication through adaptive TDM
UART interface
Transparent serial link
MAVLink protocol framing
Frequency Hopping Spread Spectrum (FHSS)
Configurable duty cycle
Error correction corrects up to 25% of bit errors
Open-source SIK firmware
Configurable through Mission Planner and APM Planner
Supply voltage: 3.7-6 VDC (from USB or DF13 connector)
Transmit current: 100 mA at 20 dBm
Receive current: 25 mA
Serial interface: 3.3 V UART
26.7 mm x 55.5 mm x 13.3 mm (without antenna)

The system provides a full-duplex link using HopeRF's HM-TRP modules running custom, open source firmware. Interface to the module is via standard 5V-tolerant TTL serial / FTDI USB serial.

The SiK firmware includes a bootloader that permits radio firmware upgrades over the serial interface, and radio firmware with configurable parameters. Firmware upgrades and configuration are fully supported in the APM Mission Planner. Configuration is also possible through the 3DR Radio configurator and AT commands.

ความเห็น