Designed for use with small indoor or small to mid-sized outdoor multirotor craft, or as a standalone camera stabilizer, the Naze32 flight control is simple to setup, with configuration based on the familiar “MultiWii” software.

Specifications:

• Right Angle Version
• 36x36 mm
• 5.3 grams (no headers, 7.3 grams with)
• 2000 degrees/second 3-axis MEMS gyro + accelerometer (MPU6050)
• 3-axis magnetometer (HMC5883L)
• Barometric Pressure sensor (MS5611)
• Flexible motor outputs, support various airframe types -
• Quad/Hexa/Tri/Bi/Y4/Y6/Octo/Camera Gimbal. (Default is Quad-X)
• Up to 8 ch RC input - supports standard receivers (PWM), PPM Sum receiver (FrSky, etc), or Spektrum Satellite receiver.
• Built in FrSky telemetry inverter (shared w/main port)
• Battery voltage monitoring
• Modern 32-bit processor running at 3.3V/72MHz (STM32F103CB).
• 16Mbit onboard SPI flash
• Onboard MicroUSB for setup and configuration
• LEDs so bright, they will blind you
• MultiWii-based configuration software for easy setup
• rev5 hardware
• Made in JAPAN

RC input breakout cable is available in the link below to allow connecting to 4 channel+ receiver.

• User manual found HERE.
• Configuration software found HERE. (Chrome)

• ***NOTE*** To ensure driver compatibility, please connect the board via USB before soldering any pins to the board. A good source for drivers that seem to be compatible with the software are Silicon Labs CP210x USB to UART Bridge VCP Drivers, which can be found HERE