Dragon 20A Pro Premuim MCU F390 Support One Shot Firmware

ค่าจัดส่ง รวมค่าจัดส่งแล้ว

จำนวน :

รายละเอียดสินค้า

Comes with BlHeli bootloader installed, and flashed with newestBlHeli 14.4 Firmware installed and tested!. Plus we pre-calibrate the throttle range so all ESC's start and reach full throttle at the exact same time. The 20 Amp ESCs BLHeli ships out pre-programmed and optimized for best performance - pre-configured - OneShot is included/ready, Great for Dampened Light settings. RUNS COOLER AND STRONGER THEN LITTLEBEE. ALSO THE SAME SIZE!

Enable Racing Mode! (Damped Light Supported)

Settings are changed/tuned for better handing during Racing!: BlHeli 14.4 Firmware! : PWM Frequency/Damped, Motor Timing, Beacon strength/Delay,PPM MIN/MAX Throttle are set to maximum performance! Pair with a Flip32 for automatic detection of all the advantages of Oneshot123

Features - BlHeli 14.4 Firmware Installed!

Continuous Current:20A
Burst Current(10s):30A
Battery:2-6 Lipo
Max Power:880W
Length:mm
Width:mm
Height:mm
Weight:g

Active Braking / Damped Light / Comp_PWM Supported
AutoShot (OneShot125 / FastPWM Auto Detect)
Customized to drive all motors without sync issues or cogging.
To enable new features on Baseflight:
- On Configuration tab, check "Enable OneShot" and "Enable FastPWM"
- Scroll down and click "Save"
To enable new features on Cleanflight:
-On Configuration tab, check the "Enabled" box next to "ONESHOT125" Feature
-Scroll down and click "Save"

Test Results