Beta Flight F4 + PDB + STM32 integrated OSD flight controller DSHOT
800.00 ฿
This is a flight controller that uses STM32F405 with mpu6000 mainstream FPV small rack, input voltage 2S-6S, comes with BEC-5V output 3A current, supports mainstream PPM, SBUS, IBUS, DSM2 / DSMX, etc. machine. There is LED_STRIP interface, active buzzer interface. Integrated OSD function, support OSD parameter adjustment, support the latest DSHOT ESC.
Hardware Configuration:
Main control: STM32F405RGT6
Sensor: mpu6000
Receiver: Support PPM, SBUS, IBUS, DSM2 / DSMX, etc.
LED_STRIP interface
Active buzzer interface
No black box
Built-in ammeter, current detection
OSD interface
Comes with BEC 5V 3A
Dimensions 42 * 36MM (including the length of the bonding wire pad)
Screw hole spacing 30.5 * 30.5MM
Diameter 4.1MM
Weight 9.4g
New F4 flight control:
1. Using OMNIBUSF4 firmware
2. The main control is STM32F405 GRT6 refresh rate up to 8K.
3.PCB 3OZ copper thickness enhances current stability and rapid heat dissipation
4. BEC is 5V3A output
5. Exposed pads are convenient for soldering, and can discard the traditional distribution board.
6. Compatible with all ESCs in the market
7. The flight control IMU integrated OSD does not need to flash firmware independently, and supports BF ground station to adjust OSD
8. Integrated ammeter, which can monitor current power consumption and other data in real time
9. You can use the remote control to adjust the data such as flight control PID and OSD
10. The open port can adjust the image transmission from OSD, such as power, frequency band, frequency point (the image transmission supporting this function such as the black sheep image transmission, and the upcoming DYS image transmission)
11.F4 flight control adopts four independent shock-absorbing balls, which can filter and offset the vibration of the motor to make the flight experience better
ESC M1-M4: Connect the ESC power cord
V + -V-: the positive and negative poles of the power cord corresponding to the ESC, with ‘-’ as the ground wire.
B +-B-: Lithium battery input
BOOT: BOOT button (used to flash firmware)
+ 5V: With 3A output, it can be connected to image transmission, receiver and camera at the same time.
GND: ground wire
Vout: Video output, connect image transmission image signal line
Vin: Video input, connect to camera signal cable
LED: Programmable LED_Strip signal line output
RX6 (S): Connect SBUS receiver here
RX1 (D): Connect DSM2 / DSMX / IBUS receiver here
PPM: Connect PPM receiver here
VBAT: the positive electrode of the wide voltage image transmission power supply (synchronized with the battery voltage), where the voltage is the power voltage
BUZ +, BUZ-: BB ring connection point (only supports active buzzer, distinguish positive and negative)
RX3, TX3: serial port URAT3
Delivery list: F4 flight control 1pcs
Shock Absorber 4pcs