MULTICOPTER ทั่วไป -> บอร์ดคอนโทรลอื่นๆ Other Controller Board -> NTX F7 Flight Controller

NTX F7 Flight Controller

1,680.00 ฿

ค่าจัดส่ง รวมค่าจัดส่งแล้ว

จำนวน :

รายละเอียดสินค้า

ทุกอย่างครบใน 1 เดียว ตัว TOP ของ F7

NTXF7 Betaflight F7

VTX 25/100/200/400/600mw

***********************************

New F7 flight control:

1. Using F7 firmware

2. The main control is STM32F722 with a refresh rate of up to 32K.

3.PCB enhances copper thickness, enhances current stability and fast heat dissipation

4.BEC is 5V3A output

5. Exposed pads for easy soldering and the ability to discard conventional splitter boards.

6. Compatible with all ESCs in the market

7. Flight Control Integrated OSD does not need to independently write firmware, support BF ground station to adjust OSD

8. Integrated galvanometer, real-time monitoring of data such as current consumption

9. You can use the remote control to make OSD adjustment data such as flight control PID (TX5 configuration OSD adjustment, IRC Tramp)

10. Open ports can be adjusted from OSD, such as power, frequency band, and frequency.

11.F7 flight control adopts four independent damping balls, which can filter and offset the vibration of the motor, which makes the flight experience better.

Interface description:

GND M1-M4: Connect the signal line corresponding to the ESC

+ -: Corresponding to the positive and negative poles of the ESC power cord, with the '-' as the ground.

B+ B-: Lithium battery input

+5V: With 3A output, it can be connected to the picture transmission, receiver and camera at the same time.

GND: Ground

VIN: video input, connected to camera signal line

LED: Programmable LED_Strip signal line output

RX2: Connect PPM, SBUS, IBUS, DSM2/X receiver

TX3, RX3, TX1, RX1, TX2, TX4: Reserved UART port

TX5: The board is internally connected to the OSD Assistant (IRC Tramp Protocol).

VBAT: Wide voltage map power supply positive (synchronized with battery voltage), where the voltage is the power voltage

BUZ+, BUZ-: Active buzzer connection

Button function:

BOOT: Used as a firmware to enter DFU mode

FR: VTX transmission frequency adjustment button (long press and short press), blue, green LED indication

POW: VTX transmission power adjustment button, red LED indication

Figure transfer manual adjustment:

FR button Switches the frequency point.

Short press: switch channels, 4 blue LEDs indicate channels.

Long press (2 seconds): switch group, 3 green LEDs indicate group.

There are 48 frequency points, and the specific channel frequency refers to the frequency list.

ความเห็น

สินค้า

ชิ้น

ราคารวม

0.00

ราคาจัดส่ง

0.00